by KTL » Fri Feb 01, 2013 12:14 pm
Yes the large SRP rear bar (hollow) is a large diameter and comes very close to the trans crossmember. But it's not a problem because the sway bar is solidly fixed in place by it's bearing blocks on the Wevo mounts. You also may find, depending on how low your car sits due to your choice of wheel & tire combo diameter/profile, that the SRP lever arm is very close to the ground. Be sure to check your height because once you weld that Wevo on there, it'll be a real bear to remove should you want to raise it!
That said, with my '79SC racecar, I was able to use the original locations of the sway bar mount. I run 275/40-17 so my wheel & tire diameter is actually a bit taller than the typical ~25 in. OD Porsche has used over the years. Guys who run the Hoosier 275/35-15 "cheater" tires are closer to 23 in. OD and that shorter height does indeed make a big difference in how low your lever arm gets to the track!
Kevin
'79 SC widebody sorta-934 looking thing